Kits For Classroom Electronics #2 - Op Amps (#4308)

This is the Op Amp Prototype Development PCB Kit for Classrooms. It includes a double-sided PCB designed to help in your Single Op Amp circuit experiments along with a couple of the LM741 Op Amps in a DIP-8 package. This PCB has been developed so that you can build a wide variety of circuits.

It includes 3 inputs for the Inverting side and 2 inputs for the Non-Inverting side with a potentiometer. The feedback loop includes provisions for a potentiometer with a resistor in series along with a capacitor in parallel with them.

It has provisions for Dual power supplies with bypass capacitors but you can jumper the minus power supply to Ground for single power supplies circuits.

It includes a potentiometer for Offset on pins 1 & 5 with pin 8 not connected. This PCB can be used with ANY standard Op Amp such as the LM741, TL071, LF351, OP27, and many more.

There are a ton of designs that you can build. Just populate the parts that you need for an incredible array of circuits. Use this as a Prototype Development Board to design your circuits or use it in the actual project.

This kit also includes different values of 1/4 Watt Leaded Resistors, NPN & PNP Transistors, Aluminum & Ceramic & Tantalum Capacitors, Signal & Power & Zener Diodes, LEDs, Trimpots, an Electret Microphone, a miniature Speaker, Pushbutton Switches, an IC Socket, and more. It also includes some Electronic Hardware so that you can interface your circuits to the outside world.

This kit includes 10 identical sets of these.

This kit does not include the tools you will need to assemble the circuit. You will need tools such as a soldering iron, solder, wire cutters, etc. To assemble the kit, open and print the Schematics and the Parts List below. The General Instructions are helpful notes.

General Instructions      Schematics      Parts List