Guitar Effects Pedal DIY Kit - 1 Potentiometer - 1590B

This is for those individuals that want to design their own Guitar Effects Pedal. It provides a PCB designed to fit nicely in a Hammond 1590B enclosure. You can design your own Pedals with provisions to accommodate one potentiometer.

The PCB has 554 plated-thru-holes spaced in 0.100" intervals. The holes are 0.036" with 0.070" annular rings. To allow for maximum height inside of the 1590B enclosure, the PCB is 0.020" thick. PCB is FR-4 with Blue Solder Mask. The PCB is designed for optimum space usage and component placements. 

The PCB has room for one potentiometer and accommodates two 1/4" phono jacks, one on each side. The corners are notched so as to fit snuggly in the enclosure. The holes for mounting the Potentiometers are 0.67" in diameter. You will also get 4 clear rubber feet for placing under the PCB when placing it in the enclosure. This is to maintain an even offset from the PCB to the enclosure.

This kit includes the following:

... One PCB.

... One standard size 3PDT Foot "Stomp" switch which is a must when making your own Guitar Effects Pedal

... One standard 2.1mm DC Power panel mount connector with mounting nut.

... Two 1/4" Phono Jacks with mounting hardware. These are mono jacks.

... Four Rubber feet for PCB interior mounting.

The Footswitch comes with a NightFire Electronics designed PCB developed for easy installion. It provides true bypass. Check the Footswitch PCB Schematic for circuit and layout. You get the option of using it or not.

It is designed to fit a Hammond 1590B enclosure which is not supplied.